The today's setup consists of unknown ferrites, a signal generator for power source (hence low power input). According to the theory behind PPMT one of the output coils should have much lower voltage than the other.
Any feedback is appreciated.
Edit: I've placed IRF540 MOSFET in series with the primary and drove it with 12V. The measured current on the primary was about 1A (max, across 0.1 Ohm ceramic R). Core NOT in saturation (no peak current).
The input current was exactly the same with or w/o the small E cores.
Also the input current increases equally if I short the first or the second output coil (if it works in PPMT mode shorting one of the output coils should increase the load differently than shorting the other output coil I guess).
Any feedback is appreciated.
Edit: I've placed IRF540 MOSFET in series with the primary and drove it with 12V. The measured current on the primary was about 1A (max, across 0.1 Ohm ceramic R). Core NOT in saturation (no peak current).
The input current was exactly the same with or w/o the small E cores.
Also the input current increases equally if I short the first or the second output coil (if it works in PPMT mode shorting one of the output coils should increase the load differently than shorting the other output coil I guess).